THE LUCA 360 IS A SAW DESIGNED AND BUILT FOR THE PERSON WHO NEEDS AN ACCURATE AND VERSATILE SAW AT AN AFFORDABLE PRICE.
Automatic & Manual
In the 'Automatic' mode, the operator can program up-to 9 lines of cuts each, with a maximum of 99 repetitions.
In the 'Manual' mode, the operator can position the blade to the first line of cut and choose to perform a blind or an End-to-End Cut. The operator can enter the transfer width for the next cut and hit the enter button on the PLC. The PLC positions the bridge to the required width at an accuracy of 0.1mm.
Pneumatic Head Tilt for Mitre Cuts
A simple flick of a flip switch charges a RAM that tilts the blade housing downwards to 45 degree. A mechanical stop is provided that can be adjusted to suit the angle of tilt.
In both the the 'Automatic' or 'Manual' mode, the operator can line up the blade to the first cut using the 5mW laser liner that is aligned with the blade.
Blind cut limits can be programmed into automatic cuts by defining the Start and End points for each cut. If Start and End points are not defined, the cuts will be 'End-to-End' or 'Through' cuts.
The Saw head can be rotated to a full 360 degrees. Bridge transfers are always parrallel to the blade angle. Cutting direction is always the in line with the blade.
A high pressure hydraulic RAM attached the table frame tilts the table towards the front to a 80 degree angle to the ground. A simple selector flip switch is mounted to the side of the hanging pendant.
The team at Proform understands that buying stone machinery is a big decision, one that can be extremely costly when breakdowns occur and equipment don't run to full capacity. That’s why we provide our customers with unparalleled service and support for all machines throughout Australia. From on-site installation and training to after-sales telephone and in-person support and repairs, our professional sales and service team will keep your valuable asset running.